MXBON TB625 is a black, thermal resistant, high viscosity instant adhesive. It has been specially formulated to provide impact, peel and improved resistance to heat, humidity or damp conditions, which can be used for virtually any type of fastening job. It has been specially formulated to achieve the strongest possible bond between well mated, non-porous surfaces, such as rubber, metals, plastics, glass, etc. MXBON TB625 is a one-component, solvent free system and does not require the use of a catalyst, heat or clamps. When a thin layer of MXBON TB625 applied between two surfaces comes into contact with atmospheric moisture, a rapid polymerization occurs producing the ultimate bond.
DIRECTIONS FOR USE:
Make sure the surfaces to be bonded are clean and dry (preferable to solvent-wipe plastics, glass, and rubber, and to
acid-treat metals)
Dispense a drop or drops to one surface only. Apply only enough to leave a thin film after compression.
Press parts together and hold firmly for a few seconds. Good contact is essential. An adequate bond develops in less than one minute. (Maximum strength is achieved in 24 to 48 hours)
Wipe off excess adhesive from the top of the container and recap MXBON TB625 if left uncapped, may deteriorate by contamination from moisture in the air
HANDLING AND STORAGE:
Storage: Keep products in the unopened container in a cool and dry location. Best when stored at 2 to 8ºC. Temperatures less than 2ºC can adversely affect product properties. Do Not Freeze. Keep container tightly closed until ready for use.
Handling: Material removed from containers may be contaminated during use. Do not pour back any product to the original container. Misuse of product will void all warrantees.
