MXLOC 72 is designed for the permanent sealing and locking of threaded fasteners. The product is a single component anaerobic, high strength, acrylic based threadlocker. The product cures when confined in the absence of air between close fitting metal surfaces and prevents leakage and loosening from vibration and shock.

DIRECTIONS FOR USE:

1. For optimum performance surfaces should be clean and free of grease.
2. If the material is an inactive metal consider using activator.
3. Apply several drops to the bolt & nut.
4. Assemble and tighten as required.
5. Shake the product thoroughly before use.
6. To prevent the clogging of the nozzle, do not let the tip touch metal surface during application.

FOR DISASSEMBLY:

Use localized heat to bolt or nut, disassemble while hot.

FOR CLEANUP:

To remove cured product use a combination of solvent and abrasion such as a wire brush.

PRECAUTION:

1. Use proper ventilation, avoid contact with skin and eyes.
2. If contact with skin occurs, rinse with warm water or dissolve gradually with appropriate debonder.
3. Do not try to remove forcibly.
4. If adhesive gets into eye, keep eye open and rinse thoroughly. Seek medical attention immediately.
5. Keep well out of reach of children.

STORAGE:

Keep adhesive in a cool, dry place optimal storage 8°C21°C, is recommended unless otherwise labelled. To prevent contamination of unused material, do not return any product to its original container.